Atlanta Water Line Replacement - Do It Yourself

Replacing corroded, clogged water lines in Atlanta is necessary in order to increase Atlanta water pressure. What you should do first is to start with the worst portions, including the primary valve, meter and the shutoffs fixture. After which, replace the horizontal lines and then the vertical lines for the last. If you are provided with lower water pressure within your home and are holding conventional galvanized steel lines, possibilities are that they are clogged and corroded with rust or some other minerals. Professional water line replacement is costly, which make range around some thousands of dollars.

However, you can normally do the task yourself, or maybe at least fix the worst from the problem. The horizontal lines and elbows within your basement or the lowest levels are often the major culprits. But then, replacing the entire plumbing is surely a huge job to accomplish. You may save huge amounts and make the job smaller by trying out the incremental approach. This approach means that you will begin the job through replacing the conventional water meter then continuing to the next possible suspects.

You may begin through opening the hose bib outdoor nearest to the meter. When you think there is a low flow in that area, consider the water meter. When the fittings of meter are quite smaller as compared to the lines heading out and into it, the water meter itself is the one reducing the flow. Access your water function or utility to check if it provides a 1inch meter. If it does, let the utility shut the water off in order for you to be enabled of installing bigger shutoff pipes along with your new meter. The next step is to replace the initial 15ft. of your former galvanized line coming out from the meter with an inch of PEX or copper. Several times, the improved volume of the bigger lines is sufficient to compensate the restriction within pipes further down the flow.

When the pressure of water is still very low, begin replacing the former stop pipes to the toilets and sinks. The galvanized elbows and stop valves increase crud just the way other pipes in your house do. You may turn the primary water valve off and then unscrew your stop valve. After which, you may dig out any accumulation you observe within the galvanized fitting and then install your newly purchased stop valve. Attach the other end of the new bendable supply tube to your valve and then route other of its end into the bucket. Open the valve then flush out or release any wobbly crud that is left from the cleaning process. If the water you see runs clear, you can now turn it off then install the supply tube into the toilet or faucet. You can redo the process at every fixture which you think has the low pressure.

Doing these procedures mentioned above is much favorable to you than spending a lot hiring a professional service provider. With the proper knowledge, you can only do your own Atlanta water line replacement in no time.